Delivery
* Free delivery above Rs. 1000* COD payment upto Rs. 5000* 7 days easy replacement policy * Bulk orders are shipped through surface and therefore might take more than 10 days for delivery
We have a site-wide replacement policy under the following conditions:
1. Wrong order.
2. Defective or damaged product.
3. Considerably different from the description on ShakeDeal's platform.
4. In case of bearings or power transmission belts, replacement will not be accepted if the seal or shield has been removed.
5. The replacement has to be initiated within 7 days of receiving the order.
100% Authentic and Genuine Products. Secure and Safe Payments.
NA
NA
Description
Suitable for steel, aluminum or copper brake pipes with a pipe-Ø of 4.75 mm
A beading head can quickly, accurately and easily be produced on the brake pipe with the tool set KL-0117-2 KB, consisting of beading tool, pipe bending tool and brake pipe peeling tool
This tool is specially designed to enable a flanged head to be produced according to DIN F Standard on a brake pipe in the vise. It also enables the section repair of a brake pipe directly on the vehicle (for example after accident damage).
The power train (engine/gearbox) does not need to be removed and installed when this tool set is used.
The interchangeable clamping jaws with a clamping surface of approximately 65 mm ensure the safe clamping of the brake pipe without the risk of damaging it.
Advantages:
The brake pipe is securely held in the beading tool without the risk of deforming the pipe, thanks to the interchangeable clamping jaws.
Beaded heads are produced accurately according to DIN F Standard
Ball-bearing press piece
Limit stop for accurate length, thus accurate material specification for the beaded head.
Ergonomic handle for beading while on the vehicle
Built-in holder for clamping into a vise
Substantial time and cost savings
Accessories:
KL-0117-206 Additional set for pipe-Ø of 5.25 mm
For bending the new plastic-coated brake pipes from VW-Audi with a pipe-Ø of 5.25 mm
Select EMI as your payment option at the time of payment.
Final EMI is calculated on the total value of your order at the time of payment.
The Bank charges annual interest rates according to the reducing monthly balance. In the monthly reducing cycle, the principal is reduced with every EMI and the interest is calculated on the outstanding balance.
The is no minimum order value to avail the EMI payment option.
While you will not be charged a processing fee for availing ShakeDeal’s EMI option, the interest charged by the bank shall not be refunded by ShakeDeal.
You may check with the respective bank/issuer on how a cancellation, refund or pre-closure could affect the EMI terms, and what interest charges would be levied on you for the same.
For select banks, the interest amount on the first EMI will be calculated from the loan booking date till the payment due date.